Spine Dot Engine

MRI - DotGO - Spine Dot Engine - Screenshot
Spine Dot Engine
Spine Dot Engine
Spine Dot Engine

Around 12% of the population has LSTV (Lumbosacral Transient Vertebra). Defining the exact vertebrae can pose a challenge to the surgeon if there are anomalies. Manual spine vertebral and intervertebral disc labeling is time consuming. The Spine Dot Engine optimizes cervical, thoracic, and lumbar spine imaging for a wide range of patients and conditions.

For C-Spine Imaging

  • Reduce workflow steps with automated vertebrae labeling
  • Automatic detection of spine geometry
  • Reduction of metal artifacts with WARP1

For L-Spine Imaging

  • Reduce workflow steps: automated vertebrae labeling, drop & snap positioning
  • Automatic detection of spine geometry
  • Reduction of metal artifacts with WARP1
  • Consistent positioning independent of spine curvature

General Requirements

System

Minimum Software Version

syngo MR D13

Other

Also available for:

MAGNETOM Prismafit

MAGNETOM Skyrafit
MAGNETOM Avantofit


Please Note: Additional technical pre-requisites may apply. Upon receiving your request, your local Siemens representative will clarify whether your system meets the requirements.

İlgili Ürünler, Servisler ve Kaynaklar

1The MRI restrictions (if any) of the metal implant must be considered prior to patient undergoing MRI exam. MR imaging of patients with metallic implants brings specific risks. However, certain implants are approved by the governing regulatory bodies to be MR conditionally safe. For such implants, the previously mentioned warning may not be applicable. Please contact the implant manufacturer for the specific conditional information. The conditions for MR safety are the responsibility of the implant manufacturer, not of Siemens.